The Raindance Rainfall AIR overhead shower, without lighting, for wall mounting, with AIR injection technology and Rubit cleaning system.
A 280mm x 540mm flat panel, consisting of:
240mm shower with Rain AIR injection.
4 Whirl AIR spray units set in a 208mm wide panel with tilting mechanism.
Rain Flow 176mm wide angled waterfall shower.

Flow rate: Rain Flow (highest): 30 litres/min at 3 bar.
Recommended minimum working pressure: 3 bar.

The following takes you through the controls and parts that you will require to operate the Rainfall overhead shower.

You will require the following:
1 x High-flow thermostat.
2 x ibox universal concealed parts (one for the thermostat and one for the shower head).
1 x Shut-off valve (0.75 inch).
1 x QUATTRO diverter - 0.75 inch.

If you want to add a separate hand shower OR body jets (but not both), you can control these from the same thermostatic mixer by merely adding another shut-off valve (0.75 inch) to the standard system list above.

If you want to add two further showers, for instance, a hand shower AND body jets, you can control these from the same thermostatic mixer by adding a TRIO diverter to the standard system list, instead of the 2nd shut-off valve. Alternatively in this situation, the Trio diverter could be replaced by 2 x shut-off valves for the optimum flow rate of water, therefore giving 3 shut-off valves in total; one for the Rainfall overhead, one for the bodyjets, and one for the hand shower.

PLEASE NOTE: It is recommended that you talk to a good plumber who can advise you on the size of stored hot water tank and hot water usage that you will require to operate this set-up for any given time.

Please phone us on 0870 743 0917 to discuss your requirements if you have any questions.

Colour: Chrome

Length: 548mm

Width: 280mm

Height: Back Panel: 160mm

Suitable for: Pumped & Pressurised Systems