ibox Universal concealed part, required for installation with all Hansgrohe concealed bath and shower mixers (both thermostatic or non-thermostatic), except one option in the Focus range, which requires its own version of the ibox (13620 180). Complete with 3 x 0.75" to 0.5" reducers and one 0.75" cap for reducing to 0.5" pipework, when required.

PLEASE NOTE THE FOLLOWING:

It is recommended that you have a minimum of 1.5bar pressure for all Hansgrohe concealed bath and shower mixers, with the exception of Highflow thermostatic mixers, which are able to run on low pressure down to 0.1bar, so long as any product being used with it is also suitable for low pressure. Minimum pressure of end products such as shower heads vary and requirements will be greater for feeding multiple shower outlets at the same time and shower set-ups with a larger flow rate of water than around 20 litres per minute - please call for advice if required.

Works with condensing combination boilers.

You will require a pump for use with gravity-fed water systems, if not fitting with a Highflow thermostat.

Installation depth required is 82mm - 110mm. The ibox is designed to be trimmed back to meet flush with the tiling. The maximum it can be cut back allows a minimum of 82mm from the outside of the tiling to the back wall. If you have less than 82mm depth, you can use a reduction collar (below) to bring the ibox further out of the wall, bearing in mind that your concealed mixer unit that installs into the ibox will stands 22mm further out from the wall.

Please call on 0870 743 0917 for any further information required.

Made from recycled plastic.

WRAS Approved

Suitable for: Pumped & Pressurised Systems